Specification:
DC POWER SUPPLY:
Fixed DC power supply: (Minimum) Voltage range: +/-5V~+/-12V. Max. Current output: 0.3A. With output overload protection.
Dual DC power supply: (Minimum) Voltage range: +/-3V~ +/-18V, continuously adjustable. Max. Current output: 1A With output overload protection.
AC POWER SUPPLY:
Voltage range: 9V~0V~9V Max. Current output: 500 mA. With output overload protection.
SIGNAL GENERATOR
Pulse generator: (TTL level). Frequency range: 1Hz~10KHz /4 settings, continuously adjustable. Fan out: 10 TTL load.
Pulse switches:
2 independent output, TTL level with Q, Q output, pulse width > 5ms. Fan out: 10 TTL load
Data switches:
8 sets independent control output, TTL level with Debounce circuit.
Fan out: 10 TTL load
FUNCTION GENERATOR:
Output waveform: Sine, triangle, square. Output frequency: 10~100KHz/4 settings, continuously adjustable. Output amplitude: 18Vpp (open circuit) 9Vpp (50 O load).
TESTING AND DISPLAY:
31/2 digital voltmeter/ammeter.
DC voltage range: 2V~200V
DC voltage accuracy: +/-(0.3% of reading +1 digit)
DC current range: 200
Galvanometer:
Current range 50mA
Accuracy Class 2.5
LED indicator:
10 sets of independent LEDs indicate high, low logic state. Input impedance: ?100K?
Digital display:
2 sets independent 7-segment LED. With BCD-7segment decoder/driver and DP Input. Input with 8-4-2-1 code
Breadboard: 1680 tie-point breadboard on top panel can be easily put into and taken off.
Accessories: Experiment manual, connection leads, connection plugs, breadboard.
List of Modules:
Basic Device Module.
Basic Electricity Experiment Module.
Sensor Module(1).
Sensor Module(2).
Diode, Clipper and Clamper Module.
Rectifier, Differentiator Integrator Circuit Module.
Transistor Amplifier Circuit Module.
Multi-Stage Amplifier Circuit Module.
FET Circuit Experiment Module.
OP Amplifier Circuit Module 1, 2, 3, 4, 5.
Combinational Logic Circuit Experiment Module 1-5.
Sequential Logic Circuit Experiment Module 1, 2.
Low Voltage Electrical Control Module (3 is required).
Single-Phase Motor Module (1 AC 220V).
Three-Phase Motor Module (3 220V).
Load Unit Module.
System Transformer(Y).
Basic Electrical/Electronic Circuit Lab with all Module.
Accessories:
User Manual: 1 Nos
With Standard Accessories.
4mm Safety Socket.
